| Top Articles for batteries |
|
| Payments powered |
|
|
Battery Tips
|
- What is a Battery?
In science and technology, a battery is a device that stores energy and makes it available in an electrical form. It converts chemical energy into electrical energy, producing an electric current when connected in a circuit. The finished battery is an electrically connected group of cells (wired in series) that stores an electrical charge and supplies a direct current (DC). We usually call finished battery as battery pack and unfinished battery is called as cell.
- How to classify the battery?
Batteries are grouped into following categories:
Alkaline battery
Zincic carbolic battery
Lead-Acid battery
nickel-metal-hydride
nickel-cadmium
Lithium battery
Li-ion battery
Li-polymer battery
Fuel cells
Solar cells
Other types of battery
- What are the differences between Primary Battery and rechargeable battery?
A primary battery is not intended to be recharged and is discarded when the battery has delivered all of its electrical energy.
A rechargeable battery is a galvanic battery which, after discharge, is restored to the fully charged state by the passage of an electrical current through the cell in the opposite direction to that of discharge.
- What causes short lifetime of battery? How to prolong the lifetime of battery?
1)Reason:
a.Charger or electro circuit can't be fit for the battery.
b.Overcharge and overdischarge, etc.
c.Battery can't comply with the charging requirement
2)Solution:
a.Use the original charger.
b.Charge the battery after it automatically powers off , then full charge the battery.
c.Avoid erroneous usage of battery, such as heavy pressure, short circuit, fall off and so on.
- Why can't the battery be charged? How to solve this problem?
1)Reason:
a.The battery has no voltage.
b.There is problem with charger, as it has no output electric current.
c.Low charging efficiency due to external cause.
2)Solutions:
a.Test whether the charger has voltage and output electric current or not.
b.Check if the charger is well contacted with battery.
c.Activate the battery with voltage and current 1.5 time higher then the highest ones of battery. (Use this method only when the battery can't be charged.)
- What's the reason that causes battery with no voltage or low voltage? How to avoid this problem?
1)Reason
a.No voltage.
b.External shot circuit or overcharge, anti-charge
c.Cells expansion and short circuit caused by direct anode contact and continuous high efficiency electric current overcharging.
2)Solutions:
a.Check if the battery is without voltage or electric current.
b.Avoid short circuit.
c.Avoid collision and pressure among batteries.
d.Charge the battery after it automatically powers off , then full charge the battery.
- How to care and use battery?
Your new battery comes in a discharged condition and must be charged before use. Upon initial use (or after prolonged storage period) the battery may require two to three charge/discharge cycles before achieving maximum capacity. If the battery is not going to be used for more than a month, it is recommended that it be removed from the device and stored in a cool, dry, clean place. It is normal for a battery to become warm during charging and discharging. A charged battery will eventually lose its charge if unused. It may therefore be necessary to recharge the battery after a storage period.
- What should I pay attention to?
Do not short-circuit a battery. A short-circuit may cause damage to the battery. Do not drop, hit or otherwise abuse the battery as this may result in the exposure of the cell contents, which are corrosive. Do not expose the battery to moisture or rain. Keep battery away from fire or other sources of extreme heat. Do not incinerate. Exposure of batteries to extreme heat may result in an explosion.
- What is a battery cycle?
Battery run-time on a laptop is difficult to determine. Actual battery running time depends upon the power demands made by the equipment. The use of the screen, the hard drive, and other accessories results in an additional drain upon the battery, effectively reducing its running time. The total run-time of the battery is also dependent upon the design of the equipment. Generally, a new Hi-Capacity battery will run 30% to 50% longer than the old battery did when is was new.
- How can I maximize battery performance?
Breaking In New Batteries New batteries come in a discharged condition and must be fully charged before use. It is recommended that you fully charge and discharge your new battery two to four times to allow it to reach its maximum rated capacity.
|
|
|
